Cylinder Mounts
These cylinder mounts are ideal for pony bottles, suit inflation bottles or rebreather cylinders. They are made from delrin to avoid corrosion problems. They mate together in seconds making it extremely simple to remove/replace the cylinders.
The female section of the mount lines up with the male section and slide together. The pin locks the mounts into place to stop any movement Due to the design of these mounts, they are not handed, so they can be used as a left or right hand mount. These mounts are designed for holding up to 3l cylinders. It may be possible to mount 5l cylinders with them, but larger cylinders would need two mounts per cylinder.
The mounts can be purchased individually or as a pair suitable for rebreather divers. A pack consists of a cylinder mount and locking pin. Jubilee bands are not included.
Spools & Reels
The Agir reel is a good value for money, primary reel with 130m of line. It can be used for DSMB deployment as well as laying line.
The spools are supplied by Light Monkey and come in 100ft (30m) and 150ft (45m) variants.
Fin Straps
The Agir finstraps screw directly into the jetfin post, making them very secure. There are no pins that can come loose or break. The high quality spring is covered with webbing and a short rubber sleeve to aid removal.
The XL spring straps cover most boots from sizes 7 upwards. If you have small feet you may need the smaller size.
Cylinder Accessories
First Stage: Agir compact first stage for a suit inflation bottle. It comes with an over-pressure relief valve and has a brass handwheel as standard.
Deco Gauge: A glass fronted pressure gauge on a 6" hp hose. It is O2 clean, has a luminous dial and is protected by a rubber case.
Single Tank Adapter: Agir lightweight Single Tank Adapter weighing 0.4kgs. It has 3 camband slots for easy adjustment of trim for various cylinders.
Storage Pack: Agir storage pack is designed for both additional storage and soft padding of the backplate. It´s made of rugged cordura-material with an added layer of soft 3 mm neoprene. When attached to the backplate with its four screws and nuts, there´s room for an SMB to be stored. Screws and nuts are stainless steel.
The storage pack opening seals with velcro. By letting part of the SMB loop pass through the velcro lock, your gear will remain in place and but will still be released with ease.
P-Valve
Balanced p-valve supplied by Light Monkey, with norprene hose and stainless steel p-thru bolt. A low cost option for those needing a p-valve fitted to their drysuit. The package contains one p-valve and a male external catheter.